Speedometer

For 6V and 12V
Body material: Stainless steel
With odometer
0-140km/h full scale display
Dial white, black letters
With night light (with 6V, 12V bulb)
Body size: Φ61mm
Screw size: M5 x 18mm
Mounting Pitch :45mm

For 6V and 12V
Body material: Stainless steel
With odometer
0-140km/h full scale display
Dial white, black letters
With night light (with 6V, 12V bulb)
Body size: Φ61mm
Screw size: M5 x 18mm
Mounting Pitch :45mm

*Installation Precautions
■Not completely waterproof.
Water will not enter the interior from the glass side (drip-proof construction) when the meter is exposed to normal wetting such as riding in the rain, but if the meter is immersed, water will enter the interior from the bottom.
Air vents are provided at the bottom of the meter to reduce the temperature difference from the outside air due to the heat generated by the lighting and the changes in outside temperature when riding. However, fogging may occur on the inner surface of the panel during high humidity or sudden temperature changes.
In particular, when a bike stored indoors is used in the cold season, the temperature difference between the outside air and the meter will be large immediately after the bike starts running, making it very easy for the meter to fog up.

■Riding with headlights disconnected is prohibited
When bulbs with high wattage (especially headlights) burn out, there is an imbalance between power generation and power consumption, and the entire lighting system can have overvoltage.
This can cause the meter light bulbs to burn out (LEDs are not replaceable) or cause the stock regulator to fail due to increased load.
In bikes with batteries, the batteries tend to be overcharged and deteriorate.
If the headlight has gone out stop riding immediately, or switch to high beam (and adjust the optical axis) if it is necessary to ride.At this time, ride at low rpm as much as possible.
Ape50/100 battery-less models and bikes with engine modifications that run at higher engine speeds than stock have a stronger negative impact, and require special attention.
Disconnecting headlights is the same as a bulb burning out.Never install a simple headlight switch that only interrupts the lamp wiring.

■Speed warning light does not illuminate.
When this product is installed, the speed warning light of 50cc models will no longer be illuminated.Please be careful not to exceed the speed limit.

*It is a mechanically operated meter with bulb type lighting for both 6V and 12V.
*Both DC and AC power supply can be used.
*No power supply is required to operate the mechanical speedometer and mechanical tachometer when illumination is not required.
*There may be changes in product specifications due to the manufacturer's reasons.
*Depending on the lot, the product may be delivered with the old price and label with the old JAN code before the price change.