Grip Heater GH07 Switch Built-in

Grip length:120mm
For standard Handlebar:22.2mm
T10x37:8W-36W
Switch built-in

[Product Contents]
・Quantity:Pair (for Left and Right)Grip(Left:Switch built-in)
Installation Wiring
・End capetc.

Grip length:120mm
For standard Handlebar:22.2mm
T10x37:8W-36W
Switch built-in

[Product Contents]
・Quantity:Pair (for Left and Right)Grip(Left:Switch built-in)
Installation Wiring
・End capetc.

*This product has a full-wound heated wire, whereas Honda's genuine optional grip heaters have a half-wound heated wire. Therefore, the power consumption of this product is higher than that of Honda's optional grip heaters, and if the grip heaters are used at the maximum heat level immediately after engine start-up, the life of the on-board battery will be severely depleted. The life of the vehicle battery and the electrical system will be prolonged if the vehicle is sufficiently ready for start-up and running after the engine starts, idling is completed, and the vehicle has been driven 2-3 km.
*Motorcycles are not generators, so please do not use them willy-nilly, but rather use them as if you were gradually using the surplus power of your motorcycle. Also, please consider the use of handlebar covers to increase the overall effect of protection against cold and heat under low power use. Since your hands get cold because of the wind, if you can block the wind in a materialistic way, your hands will be less cold and heat will be accumulated.
*With the recent trend of expanding electrical components, we have heard from many customers that only the grip heater option is not enough. Motorcycles burn fuel to advance, and other electrical components are operated by utilizing the explosive power of fuel to generate electricity.
*Because of the high power demand, even if the car can be used at 5 of the 5 maximum heat levels when driving on highways or expressways, the battery protection function may automatically stop the power supply when the car is stopped in traffic jams or at traffic lights. In such a case, please try to start up and use again after reaching cruising speed.
*When installing on a stock or external throttle pipe, it is recommended to warm up the throttle pipe before installation to allow for thermal expansion and easier installation.
*In some vehicles, the factory-installed scanning system may cause the grip heater memory function to be initialized without the owner or dealer's knowledge. Since it is not possible to cut off the scanning system installed in the vehicle, please consider adding a switch wire to manage the system. If you do not feel any particular frustration when starting up and using the system from the first stage of initialization every time, there is no need for additional wiring.
*For full cowl vehicles and scooters, the wiring cowl will be threaded in at the time of installation, which will increase the labor cost and may require a longer period of time. Also, since this is an electrical component, it depends on the vehicle as to where the optional coupler or excess wiring is used to supply electricity. Please consult with the motorcycle store before you order the work to be done.
*Please check the condition and part numbers of the compatible throttle pipes carefully, as well as the length of the grip heater, and consider the possibility that the stock bar end may not be able to be used with the throttle pipe.
*Recently, it is very rare to find a motorcycle equipped with a heated grip heater, which is a high-end component in the delivered condition. In such cases, please confirm the actual condition of the vehicle with the vehicle dealer, and not only with the data in this application.
*In particular, it has many events in the following when mounting this product but it does not only cause warm. Also rise the battery in case of mounting to the small vehicle of the battery capacity and the amount of power generation. Please check either the current condition of the vehicle multiplied by the engine of 13.4V or more to the specified voltage. Please make sure that it has no effect with the other electrical equipment such as light become dark as use to other electrical included components. Please note that it may be unable to exhibit sufficient performance depending on the condition of the vehicle.
*It contains other parts in the photo.
*Please note that the product specification may change due to manufacturer reasons.