Handlebar

[Size]
・Width: 740mm
・Height: 80mm
・Back: 225mm
・Clamp part: Φ25.4mm
・Grip: 22.2mm

[Size]
・Width: 740mm
・Height: 80mm
・Back: 225mm
・Clamp part: Φ25.4mm
・Grip: 22.2mm

*It is necessary to remove the stock left side grip heater (HONDA PART No.35520-MLA-305) which is fixed with a strong grip bond when assembling the new REBEL 1100 at the HONDA stock from the stock handlebar. No.35520-MLA-305) and replace it with a new one depending on its condition.Even if you start the engine and warm up the grip heater to the maximum and pull it out, it is attached really tightly and it may fail in the process of removal.If it is difficult to remove the stock left side grip heater (HONDA stock parts No.35520-MLA-305), you need to purchase a new stock left side grip heater (HONDA stock parts No.35520-MLA-305) by yourself to install this product.In this case, there will be an extra stock handlebar and a stock left side grip heater (HONDA Parts stock No. 35520-MLA-305), which will be necessary to restore the vehicle to its original condition.
*When you remove the stock left side grip heater (HONDA STOCK PART NO.35520-MLA-305), you may get burned, so please use the glove to protect your hand.
*If the heater fails or is destroyed during operation, it must be replaced with a new one (HONDA Stock Part No. 35520-MLA-305).
*This product does not require any changes to the hoses / harnesses / wires, but if you are concerned, please change the brake hoses to an appropriate length.The parking brake may need to be adjusted due to the change in handling.
*Before purchasing this product, be sure to inform HONDA Dream shop to remove the stock left side grip heater (HONDA Parts Stock NO. 35520-MLA-305) and replace it with a new one depending on the condition of (HONDA Parts Stock NO. 35520-MLA-305), If it is difficult to remove the stock left side grip heater (HONDA Parts Stock No. 35520-MLA-305), it is necessary to prepare and install a new stock left side grip heater (HONDA Parts Stock No. 35520-MLA-305) to install this product. (Honda Parts Stock No. 35520-MLA-305), and that the tension of the parking brake needs to be adjusted, etc. to the appropriate length.
*The thickness of the paint on this product may vary.There may be a dullness when turning to the axle side.In this case, it is necessary to adjust the product part of the handlebar by shaving with a file.
*The punch marks on this product are for reference only.Please adjust the position of the handlebar to your liking.
*The holes in the switch box of this product may be slightly out of alignment.In this case, it is necessary to widen the hole.
*There may be changes in product specifications due to the manufacturer's reasons.