Grip Heater HG120M + Accessory Power Connection Kit + Sub Harness

[Material] Accessory power connection kit case body: Aluminum (black alumite)

[grip length]
・Right side:Grip 120mm + Collar 5mm
・Left side:Grip 120mm + Collar 5mm

[Grip diameter] Φ34

[Size (approx)]
・Accessory Power Supply Connection Kit Unit (Approx.): 22.3 x 37.8 x 36.5
・Accessory power connection kit bullet terminal (approx.): Φ3.5

[Power consumption] 8-40W

[Installation time] Varies depending on the model

[Set components]
・Grip heater HG120M x 1
・Accessory Power Supply Connection Kit x 1
・Sub Harness x 1

[Material] Accessory power connection kit case body: Aluminum (black alumite)

[grip length]
・Right side:Grip 120mm + Collar 5mm
・Left side:Grip 120mm + Collar 5mm

[Grip diameter] Φ34

[Size (approx)]
・Accessory Power Supply Connection Kit Unit (Approx.): 22.3 x 37.8 x 36.5
・Accessory power connection kit bullet terminal (approx.): Φ3.5

[Power consumption] 8-40W

[Installation time] Varies depending on the model

[Set components]
・Grip heater HG120M x 1
・Accessory Power Supply Connection Kit x 1
・Sub Harness x 1

*Decide the use of the collar according to the length of the stock grip of the vehicle.
*Please do not install the product which emits high voltage noise such as HID kit and a third party ignition coil together.This product is only for vehicles with stock electrical system.
*Please be careful when installing the product on "vehicles sold overseas", "vehicles with a low power output of 125cc or less", and "older vehicles".You may not be able to use it.
*Please use the included double-sided tape for direct attachment to the vehicle.
*Do not use the included double-sided tape to secure the handlebar bracket.
*Please do not use the grip heater with bare hands because it becomes very hot.
*Please be careful even with gloves on, as there is a risk of low temperature burns.For details, please refer to the instruction manual.
*In the case of the universal type, you need to modify the throttle tube attached to the vehicle or purchase a throttle tube separately.
*PTC thermistors are cut off by the heat of the current, and become very hot depending on the amount of current and elapsed time after cut off.In this case, it may deform or melt the main unit, which is very dangerous. Remove the interrupted device from the main unit as soon as possible.
*The main unit of the accessory power connection kit generates heat, so avoid installing it in a place where it is likely to be overheated.
*The main unit of the accessory power supply connection kit is waterproof, but the terminal part must be treated so that it is not exposed to water.
*The accessory power connection kit has a high output of 20A, but not all vehicles can use 20A.Depending on the vehicle, battery condition, or other factors, the load on the battery may increase, which may cause the battery to run out of power.
*As the grip heater is energized, there is a whining sound from the grip, but this sound is not abnormal.

*The installation of models is not checked other than those listed in the compatibility check list.If your vehicle is not listed, it cannot be installed or has not been tested.
*The installation of the product to the models that are not listed in the compatibility check list is not guaranteed.
*The color of the product may vary depending on the shooting conditions, monitor, product lot, and left and right of the set product.
*Images may contain other products.
*There may be changes in product specifications due to the manufacturer's reasons.