Cowl Bikini Type Kit

[Material]
・Body: Black gel coat finish made of FRP
・Bracket: Steel with black finish

[Material]
・Body: Black gel coat finish made of FRP
・Bracket: Steel with black finish

※商品可能為「未塗裝」樣式，請於訂購時確認需要的款式。若有任何疑問或需要協助，客服系統都歡迎使用查詢。

※商品可能為訂單成立後生產；若訂單成立後有相關取消／修正之情形，本站保有最終決定權。

*This product is made of FRP with black gel coat finish (surface).The product can be used as it is, but if it is to be painted, it must be painted at a specialized FRP painting shop with experience in FRP painting.
*When installing this product, please be sure to attach the edge moldings to the top and bottom of the bikini cowl.
*When this product is installed, the overall height is GB350/S:
*The quality of this product is checked at the time of manufacture and before shipment, but due to the nature of FRP, air bubbles may occur, so please correct the putty if necessary during ground work.
*Please drive with caution in strong winds, as you may be knocked off the handlebars.
*Because this product is made of FRP, it may shrink depending on the climate and storage conditions, and the hole positions may not match.Bolt
*This is done by temporarily fixing the bolt and installing it while deflecting it.If it still does not fit, widen the hole.Be sure to check the installation before painting.
*This product must be painted at a specialized FRP painting shop with experience in FRP painting.
*Do not paint directly on the gel coat surface.Primer, surfacer, or other primer preparation is always required.Do not apply heat to the gelcoat surface before primer coating.
*Do not use heaters, etc. when preparing the base before painting or when drying the paint.Be sure to dry the product naturally.
*Images may contain other products.
*There may be changes in product specifications due to the manufacturer's reasons.