TECH11 Mirror Bar End Mount

[Material] Component: Aluminum material
[Type] Oval edge
[Color] Black / Carbon

[Size]
・Arm length: 120mm
・Arm width: 13mm
・Total length of bar end for mounting: 20mm
・Total length of flat surfaces that can be mounted inside: 18mm
・Collar large: I.D. 13.5 / O.D. 14.5
・Collar small: I.D. 9 / O.D. 13
・Special nut: M6
Cap bolt:M6 x length 45mm
・Mirror size: 78mm (H) x 118mm (W)

[Specification]
・Wide angle convex mirror
・Common to both left and right
・ECE certification number obtained
・KIJIMA Logo


[Quantity]
・Product body: 1 pc.
・Collar large: 1 pc.
・Collar small: 1 pc.
・Special nut: 1 pc.
Cap bolt:1 pc.

[Components]
・Instruction Manual
・M6 fixed bar ends

[Material] Component: Aluminum material
[Type] Oval edge
[Color] Black / Carbon

[Size]
・Arm length: 120mm
・Arm width: 13mm
・Total length of bar end for mounting: 20mm
・Total length of flat surfaces that can be mounted inside: 18mm
・Collar large: I.D. 13.5 / O.D. 14.5
・Collar small: I.D. 9 / O.D. 13
・Special nut: M6
Cap bolt:M6 x length 45mm
・Mirror size: 78mm (H) x 118mm (W)

[Specification]
・Wide angle convex mirror
・Common to both left and right
・ECE certification number obtained
・KIJIMA Logo


[Quantity]
・Product body: 1 pc.
・Collar large: 1 pc.
・Collar small: 1 pc.
・Special nut: 1 pc.
Cap bolt:1 pc.

[Components]
・Instruction Manual
・M6 fixed bar ends

*Rearward visibility varies significantly depending on the mirror position.Please be sure to run a test run under clear skies and good visibility to familiarize yourself with the changes in visibility.
*Fit the mirror to the attached bar end and fix it with screws.The overall width of the steering wheel (overall width of the bike) varies depending on the steering wheel angle.Please measure the dimensions before assembling the installation image.
*The attached bar end is clamped between the M6 x 45mm bolt and the collar, and then installed by hanging it inside the handlebar and tightening the M6 x 45mm bolt.Since most of the bikes with stock bar ends have the threading for fixing the bar ends welded inside the stock handlebars, the collar part for fixing the bar end mirror of this product may not fit into the bar end mirror depending on the bike.In this case, if the threading of the stock handle is to be used, the bar end of this product will need to be bored out.If you have any questions, please consult with your authorized bike dealer.
*Applicable to bikes with 22.2mm diameter handlebars and 25.4mm diameter (1 inches) handlebars, and bikes with stock handlebars that do not have pre-threaded threads for fixing stock bar ends or bikes with custom handlebars that have not been threaded.
*If the bar end is threaded, it is necessary to bore the bar end part to use the stock bar end fixing bolt.
*Images may contain other products.
*There may be changes in product specifications due to the manufacturer's reasons.