PAGE TOP

Handlebar (40mm back, 30mm up) for XSR125 / XSR155 (RE46J, MTM125, BVF1, MTM155, BBS1, BBS5, BBS8, BBSA)

  • Brand: KIJIMA
  • Product ID: 204-3397

List price:

Selling price: 12%OFF

Get 47 Webike point (Around NT$ 47 )
*Can be used as a discount on your next purchase.

Pre-sale Service

Webike point

Once you select the option, estimate delivery time will be displayed.

QTY:

FITMENT

[要點]

[Material] Steel
[Size] (Refer to the size diagram)
・Part A length: 735mm
・Length of part B: 140mm
・C section length: 75mm
・D section length: 120mm
・Number of handle Φ: 22.2mm
・40mm closer to rider than the stock handlebar
・30mm higher than the stock handlebar
・Tracker bar length: 230mm
・Tracker bar thickness: 13mm

[商品描述]

[Material] Steel
[Size] (Refer to the size diagram)
・Part A length: 735mm
・Length of part B: 140mm
・C section length: 75mm
・D section length: 120mm
・Number of handle Φ: 22.2mm
・40mm closer to rider than the stock handlebar
・30mm higher than the stock handlebar
・Tracker bar length: 230mm
・Tracker bar thickness: 13mm

[注意]

*Overall width: -20mm, Overall height: +35mm (Overall width: ±20mm / Overall height: ±40mm
*If you have installed it on an XSR125, you do not need to change hoses/harnesses/wires, but if you are concerned about it, please change the brake hoses etc. to appropriate lengths.Since the handling is changed, please check and adjust the tension of the clutch cable and so on.
*Regarding the right side lever holder section when mounted on the XSR155, the clamp position of XSR155 should be fastened with the lever holder in the appropriate position.
*In case of XSR155, loosen the attachment bolt of the meter bracket and change the brake hose routing.
*Since the lever holder is designed for the XSR125, it is partially on the bent part of the handlebar.In addition, depending on the condition of the local specification license plate bracket and the way it is cut, the brake hose may not reach when the handlebar is turned fully, so the brake hose should be extended to the appropriate length.
*Even if you have a free day, it will take more time than expected to remove the cowl and work on the special bar ends, so we strongly recommend consulting with the authorized dealer where you purchased the bike before replacing it by yourself.
*The image may contain other products.
*There may be changes in product specifications due to the manufacturer's reasons.

REVIEWS FOR THIS PRODUCT(0)

0/5