PAGE TOP

Rear stand3+AxlePenetratingShaft aTouch

List price: TWD 5,437

Selling price: TWD 4,404 19%OFF

Spring Sale: Free Shipping Event from Now Until March 31!
Enjoy Free Shipping on Orders Over TWD 9,999!
※EMS shipping only.

Get 44 Webike point (Around NT$ 44 )
*Can be used as a discount on your next purchase.

Pre-sale Service

TWD 4404.000000

44 Webike point

Once you select the option, estimate delivery time will be displayed.

QTY:

[要點]

Φ8Shaft (Effective straight section 450mm)
CollarQuantity:2pc. Set (OD 30mmXT 8.5mm)
Two shaft receiving holes
Lift up amount:280-355mm (lower hole for receiving - upper hole for receiving)
Supported Arm Width:350-395mm (Largeest when using Collar - 17mm reduction)
Lift-up Time:200kg

[商品描述]

Φ8Shaft (Effective straight section 450mm)
CollarQuantity:2pc. Set (OD 30mmXT 8.5mm)
Two shaft receiving holes
Lift up amount:280-355mm (lower hole for receiving - upper hole for receiving)
Supported Arm Width:350-395mm (Largeest when using Collar - 17mm reduction)
Lift-up Time:200kg

[注意]

*For through-axle shaft cars only.
*Cannot be used for vehicles that cannot completely pass through a Φ8 shaft.
*Rear wheel removal/attachment cannot be performed during use.
*The heavier the vehicle, the heavier the operation will be if the lift is increased.
*Be sure to use the stand with the shaft support tilted (at an angle) toward the rear of the vehicle. If the stand is tilted toward the front of the vehicle, the center of gravity of the stand itself will be compromised, making it dangerous.
*Do not apply any weight other than the vehicle weight to the Φ8 shaft. If you put your full weight on the Φ8 shaft after stand-up, or rock it up and down, the Φ8 shaft may be distorted or bent.
*It contains other products in the photo.
*Please note that the product specification may change due to manufacturer reasons.

REVIEWS FOR THIS PRODUCT(0)

0/5